Dash Kits

By:Kyle Thacker




FLAT DASH KIT INSTALLATION INSTRUCTIONS

So you are looking to install a flat dash kit? Well here is some great information to help get you started.

ALIGNMENT- Every time you need to "pre fit" each section before taking away the mark off from the 3M tape. Fitting for a wood trim kit is a creative process as contrasting to a mechanical procedure. Hand and eye coordination is vital to a triumphant alignment when you are undergoing installation. As the installer you only get one opportunity to get it correct, so be sure the alignment phase has been accurately followed before taking away the shielding marking off the adhesive exterior.
Always make sure that you take all of the proper precautions when attempting a job like such, every thing should be properly cared for and treated with respect. One single mistake can ruin the flat dash kit installation process.

SURFACE PREPARATION- making sure the area is clean for the receiving section and could be the most crucial phase for a great installation. You never want to take short cuts. If you overlook these instructions it can and will cause a disappointing outcome and will cancel given manufacturer's warranty, you would not want this could ruin a great warranty and force you to come out of pocket to possibly pay for a rather large expense.

Steps 3 PRE-HEAT the wood- Pre-heat directions are showcased below.
Please beware: heat can remove foam impressions so you should be very wary.
Abide by the given steps in the sequence that follows.
DENATURED ALCOHOL OR ISOPROPYL ALCOHOL- this would be obtainable at any tools and hardware depot. Its reason would be to cleanse the area of the vehicle. Always remain cautious not to look-over this stage.
3M 4298 ADHESIVE PROMOTER- Obtainable with every kit comes a wipe on rag/sponge like tool directly from the Maker. The idea for 3M 4298 Adhesive Promoter would be to better the adhesive tie for the 3M 4229 Tape Adhesive to the area of concentration.
Once the wood finish kit is set in place, wipe down and cleanse the epoxy area with Windex. Appropriate cleaning will eliminate prints, glue, and so forth. This would be removed from the epoxy exterior and give the effect of a glossy shine appearance, which is great for the wood finish kit package. This finish can really prove to be the icing on the cake when it comes to appearance of the dash kit.
If you followed these instructions to the best of your ability, the installer will have a great experience. Incorrect installation can cause troubles that would be damaging and leave an unsuccessful dash kit wood trim production.
REMEMBER TO PRE-HEAT
always remember that your wood dash trim kit is sealed with an epoxy solution that is particularly formulated to lower the vulnerability to reduction and cracking, frequently linked with tremendous interior car temperatures.
Pre-heat every portion before installation/fitting to a temperature with a range of 84-91 degrees F. remember to keep it not hotter then one person can feel, this raises the wood equipment elasticity. This allows forming and taking shape of the contours. Start by heating the wood trim section by using a hot gun, or by inserting in direct sunlight.
I hope this article has been well informative and you have learned a lot.
If you properly follow these instructions to the best of your ability then you should have no problems what so ever.

About the author:
dash kits

Jessica has been writing articles for Millenium Enterprises since 2005.